Heating

Furnace Repair

No heat, short cycling, strange smells or noises. Safe, same-day gas furnace repair.

Furnace Installation

New gas furnaces sized for your home, permitted and installed by our own crew.

Wall & Floor Heaters

Repair and replacement of wall furnaces, floor furnaces and direct vent heaters.

Ignition & Flame Sensor

Furnace lights then shuts off? Flame sensor cleaning and igniter replacement.

Furnace Tune-Up & Safety Check

Fall furnace service with flame sensor cleaning, igniter test and carbon monoxide check.

Ductless Mini-Split Installation

Quiet, efficient heating and cooling for rooms without ducts: additions, garages, bedrooms.

Heat Pump Installation

One system for cooling and heating. Repair, replacement and conversion from gas furnaces.

Rooftop Package Unit Repair

Repair and replacement of rooftop and ground package units and gas packs.

Zoning Systems

Separate temperatures for upstairs and downstairs with dampers and multiple thermostats.

Smart Thermostats

Thermostat repair, replacement and smart thermostat setup that actually works with your system.

Ductless Mini-Split Repair

Blinking lights, error codes, weak cooling or heating, water dripping from the indoor head.

Heat Pump Repair

Cold air in heat mode, icing up, running nonstop, strange noises. All brands.

Rooftop Package Unit Installation

New rooftop and ground package units and gas packs, sized, permitted and installed.

Troubleshooting

AC Not Turning On? 6 Causes and Easy Checks

When an AC will not turn on, start with the thermostat (mode, setpoint, batteries), then the breakers, the outdoor disconnect, and the condensate float switch. If power and settings are fine and nothing starts, the problem is likely a failed control board, transformer, capacitor, or contactor, which a technician should test.

Troubleshooting

AC Runs Constantly but House Stays Hot? 7 Reasons

An AC that runs all day without reaching the setpoint is usually short on airflow (dirty filter or coil), losing cold air through leaky ducts, low on refrigerant from a leak, or simply too small for the heat load. On very hot days some long run time is normal, but if it never catches up in mild weather, have it checked.

Troubleshooting

Furnace Blowing Cold Air? 7 Causes and What to Check

A furnace that blows cold air is often just set to fan On instead of Auto, or the burners shut off after a few seconds because of a dirty flame sensor, a clogged filter, or an ignition problem. Check the thermostat and filter first. If the burners do not light or keep shutting off, call a technician.

Troubleshooting

Furnace Turns On Then Shuts Off? Short Cycling Causes

A furnace that turns on and shuts off quickly is short cycling, usually because of a clogged filter causing overheating, a dirty flame sensor, a blocked vent or intake, or a thermostat problem. Replace the filter and check the thermostat first. If it keeps cycling, a technician should check the safety switches and venting.

Troubleshooting

Heat Pump Blowing Cold Air in Heat Mode? Causes

A heat pump that blows cool air in heat mode may simply be in defrost mode, which is normal and lasts a few minutes. If it blows cold air for a long time, check the thermostat mode and filter, then call a technician for possible reversing valve, defrost control, or refrigerant leak problems.

Troubleshooting

Mini Split Blinking Light or Not Cooling? What It Means

A blinking light on a mini split is usually an error code, a filter reminder, or a sign the unit is in defrost or startup. Count the blinks, check the remote mode and the filters, and power cycle the unit at the breaker once. If the light keeps blinking or it still will not cool, a technician should read the code and test the system.

Troubleshooting

AC Short Cycling? Turns On and Off Every Few Minutes

An AC that turns on and off every few minutes is short cycling. Common causes are a thermostat in a bad spot, a clogged filter, a frozen coil, a tripped float switch, an oversized system, or an electrical or refrigerant problem. Check the thermostat and filter first. If it keeps cycling, have a technician test it, because short cycling wears out the compressor.

Troubleshooting

Thermostat Blank or Not Responding? Causes and Fixes

A blank thermostat usually has dead batteries, lost power from a tripped breaker or switch, or was shut off by a tripped condensate float switch. It can also be a blown fuse on the control board or a failed transformer. Replace the batteries and check breakers and the float switch first. If it is still blank, a technician should test the low voltage power.

Troubleshooting

High Electric Bill in Summer? Why Your AC Runs Too Much

A high summer electric bill usually means the AC is running longer than it should. Common causes are a dirty filter or coils, leaky ducts in a hot attic, a low setpoint, poor attic insulation, a refrigerant leak, or an old, inefficient system. Start with the filter, thermostat schedule, and outdoor coil, and have the system checked if run time is still high.